Wheel Tubs

Arghh..sometimes I hate my internet( I had this post done photos and all and just getting ready to actually post it to the blog when my net quit me. :/ At any rate I tacked in the stretched fender flares then I bought a sheet of 20ga. steel to fabricate the wheel tubs, marked out the sidewall cutouts using the same template I had used for marking out the well cutouts @ a 36" circumfrence, then marking out the the tops at 20" width and 57" linear length. Taran was at work this day, so I had to weld them up myself. Surprisingly enough they turned out pretty good. All of the seems including the attachment point for the tubs to the inner and outer quarter panels will be sealed with body seam sealer and undercoated to prevent any rust AND any smoke entrance from any "accidental" burnouts that may or may not occur :D